Tags

,

14718765_10208849655053516_6492334303744331809_nMake this permanent/portable hive stand for cheap or free.

For under ten dollars you can build a sturdy hive stand that can be used in either a permanent or portable situation. Since it uses relatively short pieces of lumber, sometimes you can find scraps and make one free. I have made several of these and use them as portable stands moving them around as I perform hive inspections. Along the way they sometimes get used in a more permanent way when the unexpected happens and a stand is needed for a captured swarm or an unexpected, but necessary, spring split.

Materials:
5/4″ x 6″ x 12′ treated deck lumber (#2 lowest grade)- qty. 1
2″ x 4″ x 8′ treated lumber – qty. 1
2 1/2″ nails or ~ 2″ screws – about 36

You’re going to make several 18″ cuts so if you have a table or radial arm saw set it for 18 inches first. If you don’t have either then that’s okay too – any saw will work.

Cut the 2”X4″ into 4 leg pieces each measuring 18″ (you’ll have a piece left)

Using the 5/4″ x 6″ lumber cut an additional two 18″ pieces.

Reset your saw to 24″ and cut the remaining 5/4″ lumber into 4 pieces. (you will have a short piece remaining).

The 2″x4″s are your legs. Make a sandwich by nailing two of the 24″ pieces to sandwich two 18″ legs. A carpenter’s square helps keep things perpendicular but not absolutely necessary. (don’t overcomplicate it; do one side, turn it over and repeat.)

Make another sandwich using the remaining 24″ pieces and 18″ leg pieces.

On a flat concrete surface, stand and connect the two sandwiched pieces using the remaining 5/4″ x 6″ x 18″ pieces by nailing them them to the sides joining the sandwiches. Your stand should now be complete and level.

 

Advertisements